Available in various rated load ranges:
0 - 0.5 kN up to 0 - 10 kN
0 - 0.5 kN up to 0 - 10 kN
- Special design for tension measurement in disk accumulator
- Easy to adapt
- Milled planes on the axle journal
- Robust, anodised steel housing
| Rated Measuring Ranges (FN) | 0 - 0.5 up to 0 - 10 kN |
| Rated output | 1.0 mV/V |
| Rated output tolerance | < ± 0.2% |
| Accuracy Class | 0.3 |
| Excitation Voltage max. | 12 V |
| Reference Excitation Voltage | 10 V |
| Input Resistance | 350 ±3 Ω |
| Output Resistance | 350 ±1 Ω |
| Isolation Resistance | > 10 GΩ |
| Rated Temperature Range | 5 - 50 °C Option: -10 - 70 °C |
| Operational Rated Temperature Range | Sensor: -10 - 70 °C Connection Cable: -30 - 80 °C |
| Storage Temperature Range | -30 - 70 °C |
| Reference Temperature | 23 °C |
| Temperature Influence per 10K | On the zero point (TK0): <±0.1 %FN On the calibration (TKC): <±0.15 %FN |
| Creep after 30 minutes | < ±0.05 %FN |
| Linear output signal up to | approx. 125 %FN |
| Mech. overload protection takes effect at | approx. 140 %FN |
| Overload protected1 | 200 to 400 %FN(depending on nominal force) |
| Ultimate side load | 200 %FN |
| Deflection at nominal force | 0.07 to 0.25 mm (depending on nominal force) |
| Natural frequency of the sensor | > 0.25 kHz (depending on nominal force) |
| Weight | approx. 1.6 kg |
| Connection Cable | 3m long , flexible, shielded, 4 x 0.14 mm2, total-Ø 4.5 mm |
| Sensor Housing | high-tensile steel, black finishing |
| Protection Class | IP 50 |
1 radial incoming force without additional bending or tilting moment
